Uporabljamo piškotke, da naredimo vašo izkušnjo boljšo. V skladu z novo direktivo o e-zasebnosti, vas moramo vprašati za soglasje o nastavitvi piškotkov. Izvedite več.
SET UPLINJAČA PHBH 30 B reed crankc. VESPA PX 200 E
Malossi fuel system
The greatest innovation of these new Malossi carburettor kits is the
modular intake manifold. It allows to rotate the manifold into the flange
according to the specific requirements of ones own vehicle, in order to
identify which is the best angle for fitting the carburettor.
These systems have been specially designed and calibrated for high-performance motors, and are complete with all accessories needed for assembly.
MALOSSI is the leader in the design and production of special fuel systems for motorcycles and scooters.
MALOSSI systems are the result of intense research and precision drawings and calculations. The suction pipes, reed valves, and air intakes designed by MALOSSI undergo efficiency tests and destructive tests to check their performance and reliability.
Carburetors are customized for each vehicle according to the specific characteristics of the motor and air intake, and are completely
calibrated for dosage of the air-fuel mixture under all power delivery conditions.
MALOSSI produces special components for fuel systems in order to supply a product that responds perfectly to the needs of the most demanding customer.
Carburettor with elastic connection (B) and adjusting screws on the right (D).
Products reserved exclusively for racing in specifically designed locations according to the provisions of the competent sporting authorities. We disclaim all liability for improper use
|VESPA PX E 200 2T
|2 gaskets for intake manifold thickness 0,5 mm
|flange for intake rubber ø 32 mhr
|intake manifold rubber holder for vespa phbh 30
|mhr fkm intake rubber ø 32
|bellows ø 45,5x66x170 mm for phbh 28-30 b vespa carburettors
|screw kit for vespa reed valve system
|x360 reed intake manifold kit (crankcase) phbh for vespa px e 2t 200 cc
|clamp h.9 mm tightening 32 ÷ 50
|starter cable sleeve 582 mm - ø wire 1mm
|gas cable length 1834 mm - ø wire 1,5mm
|starter cable and gas cable kit for vespa
|valve vl17 mhr with carbon petals thickness 0.30 mm
|valve vl18 mhr team with carbon petals thickness 0.30 mm